Rick: Table Saw Rolling Drawers

I wanted a way to store my TS blades and I had seen some nice drawers with dado'd sides for the blades to ride in. I also figure it should give me a place to latch some of my TS gear nearby so I started work on a three drawer roll around. By making it roll around I can pull it out for some extra surface space if I need to.

Here's the inspiration pic:

So my space under my TS wing is just over 31” tall, the cabinet it so be 18” wide, and 24” deep. I bought 22” drawer slides for the drawers. Everything is just pocket screws. It seemed the fastest way to get this going and the main thing I want to get out of this project is the drawer planning and installation. These will be my first drawers.

Of course, here are the images so far.